The last couple of months seem to have evaporated into thin air, and as a result, I missed February’s scheduled fleet update. Some thoughts from both February and March in this instalment, then. Continue reading “Fleet update, March 2019”
2002 SEAT Leon 20VT
For the first time ever in my two and a half years of owning the Leon, I calculated the fuel mileage. After a fairly even split of 200 miles of commuting and 200 miles of slightly exuberant recreational motoring, it came in at 33.5mpg. That was better than I expected, and means it would probably not take much effort to be knocking on 40mpg on a run. The only other thing of note this month was capturing a pleasing odometer reading.
When I first set out to post a monthly update on this site, I expected that it would be an easy way to find something to write about. That has not proven to be the case this month, though, because I’ve hardly driven at all. The Leon has racked up about 250 miles, while the Outback has acquired another 550 or so.
As a result, there is not much to say. Continue reading “Fleet update, December 2018”
A blown sidelight is something that might escape notice, particularly if these lights are not very prominent to begin with. That is why I didn’t realise the offside sidelight was out on my Outback until I spotted it as my wife pulled into the driveway last week.
Having followed the saga of fellow Subaru owner, Lewis Kingston, changing the sidelights on his Forester last month, I was not looking forward to discovering what would be required to swap them on the Outback. Surprisingly, it took very little effort and all of ten minutes. Continue reading “Changing the sidelights on a BL/BP Subaru Outback”
2002 SEAT Leon 20VT
Having said I should drive the Leon more in my last update, I have been doing exactly that this month. It is strange to find myself going outside and actually pausing to think about which car I want to drive. Before this, the Leon would only win out if my sole intention was blasting round local B-roads. Now I willingly choose to take it, even for commuting purposes. It really has improved that much following the work I did to it a few months ago.
2004 Subaru Outback 3.0 Rn
October began with some unwelcome noise from the rear of the Outback as the rear wheel bearing started to go bad. It turned out to be just a few hours’ work to install a new one, and all is quiet again. In the process, I noticed the rear brake discs getting thin, so those will need attention prior to the car’s next MOT in April.
You are happily humming along over England’s poorly surfaced roads in your Subaru Outback when you hit a section of freshly-laid tarmac. The road noise just about disappears, although you suddenly hear a faint whirring sound that seems to be coming from somewhere towards the rear of the vehicle. It varies with speed, and immediately your thoughts turn to the worse: Differential getting ready to blow itself apart? Gearbox going south?
In a slightly unexpected development, I have a new car. Several weeks ago, I stumbled across this Subaru Outback on eBay, and the following Saturday, went to collect it. More on that later, however.
The car has needed a little bit of work, chief of which was replacing the inner CV joint gaiters. Again, more on that later, but for the time being, it is sufficient to note that this job basically involved taking the whole front end apart. In the process of doing so, one of the control arm mounting studs undid itself from the subframe mounting point (pictured below), due to a seized nut. While not a big problem in an of itself, in the process of coming out, it got slightly twisted and ended up damaging the threads inside the hole. Continue reading “A DIY thread chaser hack”